Tradgardsteknik ST25M-5S4, Инструкция по эксплуатации, Страница: 9 / 10

Maintenance
1) Use a hose reel & hose properly rated for the job.
3) Use a flexible-hose connector between a swivel joint and inlet piping.
2) Never exceed the pressure rating specified for a particular reel and hose. Remember, even low
pressure is dangerous and can cause injury or death. Also, make sure that the size and material of
both the reel and hose are designed for the intended use.
4) Check for possible leaks at fluid connections prior to use. If a leak occurs in the hose or reel,
remove from system pressure immediately.
5) Release pressure in hose before removing fittings or performing any maintenance.
6) Filter should be drained daily and cleaned frequently, depending upon type of service.
TROUBLE SHOOTING GUIDE
▣
REELTEC reels will not assume
any responsibility for any remodeling
and modifications to our Reels or
products are manufactured by
REELEC nor for uses other than for
which these products are intended.
General Maintenance
TROUBLE CAUSE REMEDY
HOSE WILL NOT FULLY FIT ON
TO DRUM OF REEL
a) Hose is longer than specified.
b) Outside diameter of hose is larger
than specification.
c) Hose was not hand guided onto reel
and wound up evenly on drum.
a) Cut down hose to meet reels specified capacity.
b) Replace hose with a hose that meets the specified
maximum outside diameter requirements.
c) Hand guide hose on to drum to wrap evenly as it
is wound on to the reel.
HOSE WILL NOT FULLY
RETRACT
a) Outlet nozzle, gun or tool is too
heavy.
b) Spring is fatigued.
c) Installed hose is too long.
a) Add spring tension
b) Add spring tension
c) Cut down hose to meet reels specified capacity.
HOSE WILL NOT RETRACT AT
ALL
Spring has lost all tension or has
possibly broken.
a) Adjust spring tension
b) Replace the spring
REEL WILL NOT LATCH
a) Incorrect operation.
b) Dog spring is broken or worn.
a) Reel latches on first, second, third or fourth “click”
b) After forth “click” it automatically rewinds.
c) Replace dog spring.
FLUID PATH (PLUMBING
AND/OR SWIVEL) IS LEAKING
OR DAMAGED
a) Maximum pressure rating for reel
has been exceeded.
b) Application is not compatible with
plumbing and/or swivel seal
materials.
a) Replace or repair damaged components.
Consult factory.
Check maximum pressure rating of reel.
b) Contact factory to determine chemical
compatibility or environmental issues (i.e.
temperature rating)
FLUID LEAKS FROM SWIVEL Swivel seals are damaged or worn.
Replace swivel seals.
Caution : Be sure leak is not at Hose Fitting!