Tradesman M2501LW, Руководство пользователя

Страница: 11 / 27

ASSEMBLY
INSTALLING EXTENSION WINGS (FIG. 5-1)
CAUTION!
To avoid injury or possible damage to the tool, support
long work pieces by installing the extension wings to
extend the work support surface.
When using extension and stop block on the left side,
hold down clamp must also be in left side. Using hold
down clamp on the right side during this operation can
cause kick-back and serious injury to the operator.
INSTALLING THE STOP BLOCK (FIG. 5-1):
1. Slide the stop block (1) onto the extension wing (2)
2. Thread the wing bolt (4) into the stop block and tighten.
INSTALLING THE EXTENSION WINGS (FIG. 5-1):
1. Place the extension wing into the mounting holes (5) provided
in the miter saw base.
2. Thread the extension wing locking screw (6) into the threaded
hole (7) and tighten to secure extension in place.
Fig. 5-1
REMOVING OR INSTALLATING THE BLADE
CAUTION!
1. Only use a 10-inch diameter blade.
2. To avoid injury from an accidental start, make sure
the switch is in the OFF position and plug is not
connected to the power source outlet.
REMOVING (Fig. 6, 7, 8)
CAUTION!
1. Unplug the saw from the outlet.
2. Allow the blade assembly to rise to the uppermost
position. Raise the lower blade guard (1) to the upper
position. (
Fig. 6 )
3. Loosen the cover plate screw (2) with a Phillips
screwdriver (
Fig. 6 ).
4. Rotate the cover plate (3) to expose the arbor bolt (4)
(
Fig. 6 ).
5. Place the blade wrench over the arbor bolt.
Fig. 6
6. Locate the arbor lock (5) on the motor, below the miter
saw switch handle. ( Fig. 7 )
7. Press the arbor lock, holding it in firmly while turning the
blade wrench clockwise . The arbor lock will engage
after turning the wrench. Continue to hold the arbor
locking to keep it engaged, while turning the wrench
clockwise to loosen the arbor bolt.
8. Raise the lower clear plastic blade guard (1) to the
upright position. ( Fig. 6 )
Fig. 7
9.
Remove the arbor bolt/washer (4), laser guide (6), and
the blade (7). Do not remove the inner blade collar.
(Fig. 8)
NOTE: Pay attention to the pieces removed, noting their
position and direction they face. Wipe the laser guide clean
of any sawdust before installing the new blade.
11
1
2
3
4