2
Welcome to the OWPIR360S indoor 360 degree infrared motion sensor!
This product features a high level of sensitivity, excellent performance and a practical size
for convenience and safe, easy installation. It utilises the infrared energy from humans as the
control-signal source and starts the load when one enters the detection field. It can identify
day and night automatically and is extremely easy to install.
FUNCTION:
• Identifies day and night automatically. Can be adjusted for ambient light according to
your desire: when turned to ‘+’ (day/bright light), it will work during the day and at night.
When turned to ‘-’ (night/darkness), it will only work under less than 10LUX when set to the
minimum. For adjustment instructions, please refer to the Test section.
• The ‘Switch On Duration’ is added to continually when the OWPIR360S receives additional
sensor signals following the first initiation (if a presence continues to be detected). It then
switches off after the ‘Switch On Duration’ completes its cycle and the triggering source is
removed.
• Switch On Duration: this can be set according to your desire. The minimum is 10±3sec; the
maximum is 7±2min.
MANUAL OVERRIDE:
When the power is initially turned ON, the fitting operates in AUTO mode. In this mode, the
sensor turns the light ON and OFF automatically.
The MANUAL OVERRIDE function means that the fitting can be put permanently ‘ON’. In this
mode, the PIR sensor is disabled and the light stays on.
• Setting Manual Override (MO)
The lamp must be on to initiate MO. Then turn the wall switch ‘OFF’ and ‘ON’ twice (with 2
second wait between each action).
Wall switch action: OFF > ON > OFF > ON
• To change back to ‘AUTO MODE’, turn the power ‘OFF’ and wait for 10 seconds, then turn it
back ‘ON’ again.
Wall switch action: OFF > Wait 10 Secs > ON
It is important to note that the wait time between switch actions is critical for this
to function correctly. This tolerance on timing is tight to reduce the potential of
nuisance triggering of this function.
It may take several attempts to get used to setting manual override.
A video explanation can be found here:
http://www.gsme.com.au/other/outdoor-sensor/arctic-owl
Or use QR code here:
