Product Code: TQBJ12TA
Made in China to TQB Brands Pty Ltd Specifications
Page 6
Visit us at www.tqbbrands.com.au
To Lower Vehicle:
1.
Raise load high enough to allow clearance for the jack stands to be removed, then carefully remove jack stands.
2.
Insert handle release valve and slowly turn handle counter clockwise, no more then 1/2 a turn.
3.
Grasp the handle firmly with both hands. Securely hold on to the jack handle so your hands do not slip and ensure the
load does not rapidly lower.
4.
(Do not allow bystanders around the jack or under the load when lowering the jack).
4.
MAINTENANCE
If you use and maintain your equipment properly, it will give you many years of service. Follow the maintenance instructions
carefully to keep your equipment in good working condition. Never perform any maintenance on the equipment while it is
under a load.
Inspection:
Inspect the product for damage, wear, broken or missing parts (eg: pins) and that all components function before
each use. Follow lubrication and storage instructions for optimum product performance. Ensure all moving parts are clear
of dirt and debris.
Cleaning:
If the moving parts of the equipment are obstructed, use cleaning solvent or another good degreaser to clean the
equipment. Remove any existing rust, with a penetrating lubricant.
Lubrication:
This equipment will not operate safely without proper lubrication.
Using the equipment without proper lubrication will result in poor performance
and damage to the equipment. A coating of light lubricating oil to pivot points,
axles and hinges will help to prevent rust. Periodically check the pump piston and
ram for signs of rust or corrosion. Clean as needed and wipe with an oily cloth.
NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE SURFACES.
To Add Jack Oil:
NEVER USE BRAKE FLUID, TURBINE OIL, TRANSMISSION FLUID, MOTOR OIL OR GLYCERIN. IMPROPER FLUID WILL CAUSE
PREMATURE FAILURE OF THE JACK AND THE POTENTIAL FOR SUDDEN OR IMMEDIATE LOSS OF LOAD
1.
With saddle fully lowered and pump piston fully depressed, set jack in its upright level position.
2.
Remove oil filler plug.
3.
Fill until oil is level with the filler plug hole, reinstall oil filler plug.
Replace Jack Oil:
For best performance and longest life, replace the complete fluid supply at least once per year.
1.
With the saddle fully lowered and pump piston fully depressed, remove the oil filler plug.
2.
Lay jack on its side and drain the fluid into a suitable container.
3.
Fill the oil case until oil level is just beneath the lower rim. KEEP DIRT AND OTHER MATERIAL CLEAR WHEN POURING.
4.
Replace oil plug.
5.
Perform air bleeding procedure.
5.
SERVICE & REPAIR
Any Bottle Jack found damaged in any way, or found to be worn or operates abnormally should be removed from service until
repaired by an authorised service agent. Owners and / or operators should be aware that repair of this product may require
specialised equipment and knowledge. Only authorised parts, labels, decals shall be used on this equipment. Annual
inspection of the Bottle Jacks is recommended and can be made by an authorised repair facility to ensure that your equipment
is in optimum condition and that the equipment has the correct decals and safety labels specified by the manufacturer.
Lubricate
Pivots & Pins
(30/40W Machine Oil)
Add Drops
(10ml SAE32 Grade Oil)
or Air Tool Lubricant