June-22
Product Code: 2057T
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
Page 5
3.
OPERATION
Warning:
Vehicle must be properly and adequately supported before commencing work with this transmission lifter.
Removing a Transmission
1.
Before each use check the hydraulic oil level and fill to 6mm below the fill port.
2.
Once the vehicle is raised and secured on Jack Stands, clear the area underneath the vehicle.
3.
Disconnect one end of the chain and allow it to hang free.
4.
Move the Transmission Lifter underneath the transmission.
5.
Close the release valve.
6.
Pump the handle to raise the transmission lifter.
7.
Stop just below the transmission and align the saddle to the transmission with the tilt knobs.
8.
Continue raising the saddle up to the transmission to determine where you will need to adjust the supports. All four
supports need to grip and make contact with the transmission.
9.
After determining where they need to be set, loosen the threaded bolts on each support, and adjust it to the proper
setting for the transmission. Tighten the bolts.
10.
Raise the unit again to make contact with the transmission, making sure all of the supports are in firm contact.
11.
Wrap the chain securely around the transmission, and hook the chain to the bracket on the other side of the saddle.
12.
Once it is securely fastened, release the bolts holding the transmission in place.
13.
Make sure the area is clear of people and tools, and check the transmission is securely held in place.
14.
Slowly open the release valve to lower the Transmission Lifter.
15.
Move the Transmission Lifter from under the vehicle and perform the necessary maintenance.
Re-installing a Transmission
1.
Move the Transmission Lifter so that the transmission is lined up properly with its connection points.
2.
Close the release valve.
3.
Pump the handle to gradually raise the Transmission Lifter, whilst guiding the transmission into place.
4.
Secure the transmission into place using its hardware.
5.
Ensure the transmission is securely installed.
6.
Disconnect one end of the chain and allow it to hang free.
7.
Clear the area near the Transmission Lifter, and slowly open the release valve to lower the lifter.
8.
Move the Transmission Lifter clear of the vehicle.
4.
STORAGE
This Transmission Lifter should always be stored with the lift arm fully lowered in a dry location on a level surface.
5.
MAINTENANCE
Replace or repair damaged parts. Use recommended TradeQuip parts only. Non- authorised parts may be dangerous and
will invalidate the warranty. Periodic maintenance is essential for the efficient operation of Manual Transmission lifts. Lack
of lubrication can cause severe wear and or premature failure.
Changing the Hydraulic Oil
1.
Change the hydraulic jack oil at least once a year.
2.
Fully lower the Transmission Lifter, remove the oil fill plug on the side of the hydraulic ram.
3.
Tip the Transmission Lifter to allow the old hydraulic oil to drain out of the housing completely, dispose of the old
hydraulic oil in accordance with local regulations.
4.
With the Transmission Lifter upright, completely fill the hydraulic ram with a high quality hydraulic oil (not included)
until the oil just begins to run out of the oil fill hole.
5.
Open the release valve and pump the handle to bleed air from the system by following the Bleed Instructions on Page4
6.
Reinstall the oil filler plug.
7.
Clean with a clean cloth using a mild detergent.
8.
Always store the transmission lifter in a safe, dry location.
