05/20
Product Code: 1096T
Made in China to TQB Brands Pty Ltd specifications
Page 6
Visit us at www.tqbbrands.com.au
MANUAL RESET/RESTART:
If the heater is in lock-out mode, check and remove the cause of lock-out before restarting the heater. To reset, turn the
ON/OFF switch to 0 and then again to I. In case of repeated malfunction, call technical service. Turning the thermostat control
knob will NOT reset the heater.
SHUT-DOWN
1.
Move switch to "OFF" (O) position. Unplug the unit when not used for a long time.
2.
Never disconnect the heater from mains to stop it while in operation. Always allow the cooling sequence to be
completed (1097T), otherwise the residual heat could damage internal components.
3.
Do not cover the heater. Do not block the air inlet and outlet.
4.
The heater outlet is very hot during operation and after use. Do not touch! Use personal protecting equipment if
needed.
5.
Children should be supervised to ensure that they do not play with the appliance.
6.
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
7.
Unplug the heater before moving it. Never pull the cable to unplug or move the unit.
8.
Do not leave the heater unattended when in use.
9.
Never use the appliance with wet hands or when either the heater or the power cable is wet.
10.
If the supply cable is damaged, it must be replaced by the manufacturer, by a service agent or a similar qualified
person.
5.
STORAGE
TradeQuip Workshop Heaters should always be stored in a dust free dry location on a level surface.
6.
MAINTENANCE
Disconnect power prior to any maintenance. Before starting any maintenance task, shut down, unplug and let the heater cool
down for at least 15 minutes.
Regularly wipe the enclosure using a soft sponge or cloth. For very dirty parts, use a damp sponge of lukewarm water
and a mild detergent, then dry using a clean cloth.
Keep air inlet and fan free from dust and dirt. To clean inner parts, gently blow compressed air through air inlet.
Regularly inspect the power cable: if worn, cracked or damaged have it replaced by technical service.
Before storing the heater, make sure it is perfectly cool and dry. Cover the unit with a plastic bag, put it in its packing box
and store it in a dry, ventilated place.
Do not attempt any electrical repair yourself. If the heater needs service or repair, contact a qualified technician.
Do not use a faulty unit unless a qualified technician has inspected and repaired it.
When cleaning, make sure that water does not enter the unit.
Do not open the enclosure to clean the inner parts. Do not spray water into the heater.
Never use solvents, gasoline, toluene and similar aggressive chemicals to clean the heater.
7.
SERVICE & REPAIR
Any TradeQuip Workshop Heaters found damaged in any way, or found to be worn or operated abnormally, should be
removed from service until repaired by an authorised service agent. Owners and / or operators should be aware that repair
of this product may require specialised equipment and knowledge. Only authorised parts, labels and decals shall be used on
this equipment. Annual inspection of the Workshop Heater is recommended and can be made by an authorised repair facility
to ensure that your equipment is in optimum condition and that the equipment has the correct decals and safety labels
specified by the manufacturer.
