Model MAST-3 Bed Frame Accessory
Revised 10/27/2016
Page
10 of 10
Step 10: Measure length of cord [E] sufficient for the following step. Only cut to length when certain
of proper length.
1) Thread rope [E] through hole on one side of rail [J]. Do not make a knot.
2) Run rope up through outer hole on top [G], across and down through the opposite hole.
3) Run rope down to hole in the opposite rail [J]. Do not make a knot.
4) Run rope end to pulley, loop around and tie a knot. Repeat for opposite side.
Step 11: Tighten all hardware. Make sure all assembled parts are tight and secure.
