Revised 6/11/18 Copyright © 2018 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 8
PART 3 Direction of Vent and Securing the Hood
MOUNTING HOLES:
Because the
TRADE-WIND
®
S7200CD Series BBQ Hood was designed for all applications, no mounting holes
have been pre-drilled. This allows for custom applications for mounting. The hood should be attached to the
framing through the top and back, whenever possible. Remove the filters. Mark and drill screw holes through the
hood as required. Secure the hood by driving screws (provided by others) through the screw holes.
**NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES TITANIUM DRILL BITS. BE CAREFUL NOT TO
DRILL THROUGH THE UL LABEL OR INTO THE
HOOD’S ELECTRICAL COMPONENTS
PART 4 Use and Care
OPERATING CONTROLS:
Always activate the ventilator when using cooking appliances. Activate the ventilator a few minutes before starting
to cook to establish an airflow pattern within the room. Adjust the fan speed as needed. Adjust the dimmable
halogen lights as desired.
WARNING!
Do NOT operate the blower / ventilator system without the filters in place, or with dirty, grease laden filters.
ENERGY SAVING TIPS:
Do not operate the blower at a speed higher than necessary to remove the cooking exhaust. Turn off the unit once
the smoke and cooking odors have been eliminated. Clean filters and grease laden surfaces often to improve
efficiency.
CARE & CLEANING:
Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation.
The frequency of cleaning should be adjusted according to the type and amount of cooking. Best results will be
achieved by cleaning soiled components as soon as possible. Filters must be cleaned regularly. Using the
aluminum knobs, lightly pull the filter toward the front of the liner while pulling the backside downwards. Replacing
the filter is just as easy as taking it out. For visual instructions on how to remove the filters visit our YouTube page
(https://www.youtube.com/channel/UCwVIbi_9hbuIATTYvz43oBA).
The filters may be cleaned by hand washing in hot water using a mild detergent solution, or by placing them in a
dishwasher. Locate holes on the sides of the filter. Put filter in dishwasher with holes facing up so detergent can
enter filters. Dry the filters completely before using again. Rinse and dry with a soft lint-free cloth. Always wipe
stainless steel surfaces with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully.
>>Most common scrubber type pads will scratch the hood.
CAUTION:
If a commercially available stainless steel cleaner is used, it is important to read the labels for chlorine compounds.
Chlorine is a corrosive substance, DO NOT USE.
Follow polish manufacturer’s instructions.
HALOGEN LIGHT BULBS:
Hoods are designed for halogen light bulbs. They can be purchased at most home and/or grocery stores.
We endeavor to incorporate the best technology provided to our industry, in manufacturing the
TRADE-WIND
®
products, therefore, we reserve the right to change models, mode of operation,
and specification without prior notice.
