TracVision Track Vision M9, Руководство по установке, Страница: 11 / 29

11
Linear Quad Version Only
Follow these steps to connect the MCU and up to
four receivers.
a. Connect the data/power cable from the
antenna to the “Output to Antenna” jack on
the MCU (see Figure 20 ). Do not overtighten
the connection; finger-tight is sufficient.
b. Connect the RF1 cable from the antenna to
the “Satellite In” connector on the primary
receiver. The primary receiver controls
satellite selection if the antenna is set up for
automatic switching.
c. If you are connecting two, three, or four
receivers, connect RF cables to the “Satellite
In” connectors on these receivers.
d. Connect the receiver(s) to the customer’s
television(s). Follow the instructions in the
receiver’s manual.
If you wish to connect three or more receivers
to the antenna, see Appendix B on page 25 .
IMPORTANT!
Be sure all receivers are grounded. If the
receiver has a 2-prong power plug, run a
ground wire from the receiver’s chassis to a
suitable ground point. If a potential exists
between AC and DC grounds, connect the
wire to the MCU’s DC return instead.
IMPORTANT!
Continued
Wire the Receiver(s) and MCU
Figure 20 Wiring Diagram - Linear Quad Version
MCU
OUTPUT TO
ANTENNA
MAINTENANCE PORT RF PORT
POWER IN
+24 VDC
Vessel Power
Power In
Output to
Antenna
Antenna
Receiver #4
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
Receiver #3
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
Receiver #2
(optional)
Receiver #1
(primary)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
Data/
Power
RF 3 RF4 RF1 RF2
8