9
The receiver requires 10-16 volts DC (VDC)
power input supporting 60 watts
(5 amps @
12VDC).
a.
Before you connect the power wires, turn
off vehicle power and test the circuit to
ensure no power is present.
b.
Connect the individual power wires to a
dedicated 12 VDC circuit. Connect the
negative (black) wire to ground (power
return), and connect the positive (red)
wire to clean +12 VDC vehicle power.
NOTE:
If vehicle power fluctuates or is noisy,
KVH recommends that you use an AC/DC
power supply (KVH P/N 72-0206-01) to
provide stable power to the receiver.
c.
Plug the other end of the wires into the
“Vehicle Power” jack on the rear panel of
).
CAUTION
For your own safety, shut down vehicle
power before you connect the wires.
Connect Power
7
Figure 15 Receiver Power Wiring
Ground
Input Power
(10-16 VDC)
Receiver
Red
Black
