MultiSat Control Panel Owner’s Manual
27
Chapter 2 - Installation
Selecting the DIRECTV TriSat Group
Follow the steps below to turn on the system and set it up for TriSat
mode.
NOTE:
This system is specially configured to receive DIRECTV’s standard
and HD programming from the 101, 119, and 110 satellites. However, the
antenna has the capability to track any DVB®-compatible satellite. If you do
not wish to set up the antenna to track the three DIRECTV satellites, refer to
“Selecting Satellites to Track - DualSat” on page 46
for details on
installing a different pair of satellites.
1.
Ensure the antenna has a clear, unobstructed view of
the sky.
2.
Apply power to the receiver(s), TV(s), and TracVision
system. Wait two minutes for system startup.
3.
Press the center
MENU
button on the MCP’s front
panel to access the onscreen menu (see Figure 2-22).
Figure 2-22 Trisat Satellite Selection Menus on MCP
Install Satellite?
Yes
Next
Return
Trisat mode?
Yes
No
Return
Menu
101, 119, and 110
sats installed
USA or Europe?
USA
Europe Return
Installing Trisat
Group - Please wait
