34
Option B - Use the ACU Buttons
Use the flowchart in
Change Sat Service menu on the ACU. Then
select the desired satellite service provider.
Step 2 - Set Up the Receivers
Follow the steps below to configure the non-
SWM receivers.
DISH Network/Bell TV Receivers
Follow the steps below to run one Check Switch
test on each connected receiver.
NOTE:
Once the receivers are set up, you can switch
satellites as needed using the ACU buttons, web
interface, or TracVision iPhone/iPod touch app.
a.
Ensure the antenna has an unobstructed view
of the sky.
b.
Using the receiver’s remote control (and a
connected television), go to the “Point Dish/
Signal Strength” screen (press MENU, 6, 1, 1
on most receiver models).
c.
Choose Check Switch, then press SELECT.
d.
Choose Test (DISH Network) or Check
(Bell TV), then press SELECT.
e.
Wait up to 10 minutes for the test to complete
and the receiver’s Program Guide to load.
TIP:
Once complete, the Check Switch displays the
current satellite, followed by “OK.”
f.
Using the receiver’s remote, select the
Program Guide to ensure it has loaded
properly.
DIRECTV Latin America/Legacy DIRECTV
Receivers
Using the receiver’s remote control (and a
connected television), set the “Satellite DISH
Type” to “Round.” If you are configuring a
legacy DIRECTV receiver, be sure to also choose
“Multiswitch.”
Continued
Configuring Non-SWM Receivers
C
Figure 50 Changing Sat Service Menu
Displays Options:
Bell TV, DIRECTV, DIRECTV Latin
America, DISH Network
CONTROL UNIT
MENU
CHANGE
ACCEPT
EXIT
ANTENNA
POWER
®
T R A C K I N G S A T S
D I R E C T V 9 9 / 1 0 1 / 1 0 3
Press Next until
A B O U T S Y S T E M ?
N E X T
Y E S
A D V A N C E D O P T I O N S ?
N E X T
Y E S
Press Next until
C H A N G E S A T S E R V I C E ?
N E X T
Y E S
C A L I B R A T E G Y R O S ?
N E X T
Y E S
Содержание HD7
Страница 1: ...Installation Guide TracVision HD7 ...
