TracVision HD7, Руководство по установке

Страница: 26 / 35

27
If the ACU is not connected to an onboard
network and you wish to connect your PC to the
ACU using an ad-hoc WiFi connection, follow
the instructions below to view or modify ad-hoc
settings.
NOTE: The ACU is Bonjour
®
-enabled. Once the
ACU is connected to the vessel’s onboard network,
you can use Bonjour to easily connect to the ACU
using a PC on the same network, without requiring
the IP address. The ACU is displayed in Bonjour as:
hd7-<ACU serial number> . For more information,
visit www.apple.com/support/bonjour .
Viewing Settings
Follow the steps below to view the current WiFi
settings.
a. Use the flowchart in Figure 42 to access the
View Wi-Fi Settings menu. Then press
“Next” to scroll through the current settings.
NOTE: The WiFi state must be set to “Ad-hoc” to
enable an ad-hoc connection (see Figure 43 ). If you
need to change this setting or other WiFi settings, skip
to
“Modifying Settings” on page 28 .
b. If you plan to connect using an ad-hoc
connection later, record the following WiFi
settings:
• SSID
• IP address
• Password (if WEP is enabled)
Using an Ad-Hoc Connection
A
Figure 42 View WiFi Settings
Figure 43 Ad-Hoc WiFi State
CONTROL UNIT MENU CHANGE ACCEPT EXIT
ANTENNA
POWER
®
T R A C K I N G S A T S
D I R E C T V 9 9 / 1 0 1 / 1 0 3
Press Next until
Displays:
State, Gateway, Subnet Mask
A B O U T S Y S T E M ?
N E X T Y E S
V I E W W I - F I S E T T I N G S ?
N E X T Y E S
V I E W S E R I A L N U M B E R S ?
N E X T Y E S
S T A T E : A D - H O C
N E X T E X I T