TracVision HD7, Руководство по установке

Страница: 15 / 35

15
Follow the steps below to wire the ACU.
a. Connect the antenna’s data cable wires to the
terminal strip connector (supplied in the
kitpack), as shown in Figure 22 . Using a #0
flat-head screwdriver, tighten each terminal
screw to secure the wires in place.
b. Connect the antenna’s power cable wires to
the terminal strip connector, as shown in
Figure 22 . Using a #0 flat-head screwdriver,
tighten each terminal screw to secure the
wires in place.
c. Press and lock the terminal strip connector
into place on the rear of the ACU (see
Figure 23 ).
d. Connect the ACU’s 120 VAC power cord to
the rear of the ACU (see Figure 23 ). Then
plug the cord into a UPS or surge protector.
e. Optional - If you plan to connect the ACU to
an onboard network using the supplied
Ethernet cable, connect it to the ACU’s
Ethernet port (see Figure 24 ).
Wire the ACU
Figure 22 Terminal Strip Connector
Figure 23 Terminal Strip/Power Supply
Figure 24 Ethernet Port
1 2 11 10 9 8 7 6 12 5 4 3
Not Used Not Used
Red (+42V)
Power Cable
Black (Gnd)
Data Cable (Body Color/Strip Color)
Gry/Wht
Wht/Gry
Wht/Org
Org/Wht
Brn/Wht
Wht/Blu
Wht/Brn
Blu/Wht
1 2 11 10 9 8 7 6 12 5 4 3
Terminal
Screw (x12)
RS232
Wi-Fi
KVH and TracVision are registered
trademarks of KVH Industries, Inc.
Tested to comply
with FCC Standards
Meets requirements
ANTENNA
ETHERNET
AC INPUT
100-240V~
160W MAX
50/60 HZ FUSE
3.15A
250V~
FAST ACTING
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interence, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
Red (+42V) Blac
k (Gnd)
Not Used Wht/Gr
y
Gr
y/Wht
Wht/Org Org/Wht Not Used Wht/Br
n
Br
n/Wht
Wht/Blu Blu/Wht
Terminal
Board
120 VAC
Power
Cord
RS232
Wi-Fi
KVH and TracVision are registered
trademarks of KVH Industries, Inc.
Tested to comply
with FCC Standards
Meets requirements
ANTENNA
ETHERNET
AC INPUT
100-240V~
160W MAX
50/60 HZ
FUSE
3.15A
250V~
FAST ACTING
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interence, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
Red (+42V) Blac
k (Gnd)
Not Used Wht/Gr
y
Gr
y/Wht
Wht/Org Org/Wht Not Used Wht/Br
n
Br
n/Wht
Wht/Blu Blu/Wht
ETHERNET
11