Operator’s manual for the Pentruder MD1 Modular Drill System with MDU9 Modular Drive Unit - Original instructions
Page 22
Pivoting head-PD1 with assembled column.
1. Mount the pivoting head on the column.
2. Tighten the locking screws to that the pivoting head doesn’t glide on the column.
3. Use the ratchet to move the pivoting head to the desired position on the column.
4. Lock the pivoting head with the locking screws on the desired height.
5. To mount the column on the pivoting head, an eccentric bolt is inserted in the hole in the column,
and tightened Clockwise with a ½” handle or ratchet.
6. Now you can mount the carriage on the horizontal column, see mounting of carriage CE1 on page
!
Important!
•
Be observant so that the eccentric bolt doesn’t slip out of the column
when the column is put on the pivoting head. It MUST be completely
flush with the column side face.
•
When the adjustable male-coupling shall be adjusted please make sure
the teeth are correctly in mesh.
•
When the pivoting head is mounted, be sure that the locking screws are
tightened to give enough friction between column and pivoting head, to
keep the pivoting head from sliding down the column in an uncontrolled
way.
locking
screw
Feed shaft
