5347-MAN-038-EN1-01 230VAC
BATTERY CHARGER MODEL MPL50
INSTRUCTIONS FOR USE
WARNING
1. DO NOT USE THIS BATTERY CHARGER OUTSIDE, FOR INDOOR USE ONLY.
2. DO NOT USE THIS BATTERY CHARGER IF IT BECOMES WET OR IF THE OUTPUT OR INPUT
LEADS ARE DAMAGED.
3. DO NOT OBSTRUCT THE VENTILATION SLOTS IN THE CHARGER CABINET.
4. THE BATTERY MUST BE CHARGED IN A WELL-VENTILATED AREA.
5. WHEN THE BATTERY IS REQUIRED, DISCONNECT FROM THE MAINS BEFORE
DISCONNECTING FROM THE BATTERY.
6. THE PLUG IS THE PRIMARY DISCONNECT AND SHOULD BE READILY ACCESSIBLE AT ALL
TIMES.
A. CONNECT THE OUTPUT LEAD (RED) TO THE POSITIVE (+) BATTERY TERMINAL.
B. CONNECT THE OUTPUT LEAD (BLACK) TO THE NEGATIVE (-) BATTERY TERMINAL.
C. CONNECT THE BATTERY CHARGER MAINS LEAD TO A SUITABLE ELECTRICAL
SUPPLY. (SEE REAR OF CHARGER)
D. IF REQUIRED, SWITCH ON THE ELECTRICAL SUPPLY FOLLOWED BY THE CHARGER
“ON” SWITCH (IF FITTED).
E. MAKE SURE THAT THE MAINS POWER (RED) LED IS ILLUMINATED.
F. ALL THE RED LED’S WILL FLASH CONSECUTIVELY.
G. THE CHARGING AMBER LED WILL ILLUMINATE FOLLOWED BY THE FIVE RED LED’S
SHOWING PERCENTAGE OF CHARGE.
H. WHEN THE CHARGE IS COMPLETE THE GREEN LED WILL ILLUMINATE. THE
BATTERY. CHARGER CAN BE LEFT CONNECTED TO THE BATTERY UNTIL REQUIRED
FOR USE. THERE IS NO DANGER OF OVERCHARGING THE BATTERY.
I.
THE MPL50 CHARGER HAS BEEN SET TO SUIT VARIOUS BATTERY TYPES FROM 80
TO 500 AMP/HOUR.
7. POWER OFF MPL50 BEFORE SELECTING BATTERY SUPPORT MODE.
CHARGE INDICATION
AGM/GEL
LEAD ANTIMONY: 1.3.4.5.6.7
Ca/Ca/Ag
LEAD CALCIUM:
1.2.3.4.5.6.7
ON
FLASHING
1.
Power On -
No Charge
2.
Half output for first
hour
3.
Constant Current -
Dependant on charge
4.
Constant Voltage
Mode
5. Reducing charge
current
6. Constant voltage -
Standby mode
7. Cycle complete -
Battery did not
reach full charge.
