© 2016 Tractel
®
Inc. All rights reserved.
18
4.3 CONTINUED - ASSEMBLY OF END STIRRUPS AND
HOISTS (two line system shown) (for stirrup model
PMR0331D (ES02) and STMSTE01 (ES01))
a. Align the stirrup pin holes. Insert four gravity lock pins from
the inside of the platform. Do not hammer or force the pins
into place.
b. Use only the 5/8 inch diameter gravity lock pins and
connectors supplied by Tractel. Make sure that the pins
are not worn, bent or otherwise damaged. Never substitute
alternative pins or bolts.
c. After each pin is installed, ensure that the gravity lock is
rotated closed and nearest to vertical to prevent the pin
from dislodging (see Fig. 9 to fig. 12 page 16).
d. Bring a hoist to the top of the end stirrup.
e. Attach the hoist to the stirrup using mounting hardware
provided by your supplier.
f. The saddle mounts the hoist controls inbound to the stage.
See fig. 17 & 20.
Fig. 17
Universal End Stirrup
Outside and Left View
Fig. 18
Universal End Stirrup
Inside and Right View
PMR0331D (ES02)
Fig. 19a
End Stirrup
Inside and Right View
Fig. 19
End Stirrup
Outside and Left View
STMSTE01 (ES01)
PMR0332 end stirrup Safway
- Hoists should be disconnected from the Stirrup for
storage and transportation
- In case of obstruction during the use of the
platform the hoist installation must be checked
before reusing
- No modification of any components of the platform
equipment must be done.
WARNING:
Fig. 20
Safway Universal End
Stirrup Outside and
Left View
Fig. 20a
Safway Universal End
Stirrup Inside and
Right View
