Tractel dynafor LLXh 100 t, Руководство по эксплуатации и обслуживанию

Страница: 10 / 183

10
2.2 Anchoring accessory
Any shackle that complies with the relevant regulations can be used for dynafor™ LLXh to be mounted
onto a traction line, as long as it complies with the dynafor™ LLXh maximum capacity.
2.2.1 Size in mm
3 INSTALLATION, UTILIZATION AND UNINSTALLATION
3.1 Conditions prior to set-up and use
- Altitude: Up to 2000 m
- Relative humidity: Max 80%
- Degree of pollution assigned: 2
Before setting up and using the dynamometer you must:
a) make sure that there is no stress value shown when the appliance is not subject to traction.
Should this occur, refer to Chapter 11 Operating Anomalies and Troubleshooting.
b) make sure that the sensor batteries and display unit power pack are adequately charged.
c) make sure that there is a good radio link between the sensor and the display unit.
d) use the "ID" icon to check that the sensor serial number shown on the sensor plate is the
same as the sensor serial number shown by the display unit (see section 6.2.2 and section
6.2.3).
3.2 Installation
When installing you must:
a) make sure that the load line anchoring point(s) are sufficiently robust in relation to the
traction that will be applied.
b) make sure that the anchoring accessories at either end of the dynamometer are compatible,
and that they comply with the relevant regulations.
c) make sure that clevis pins are well locked, with the nut screwed down to the maximum, and
make sure that the hook safety latch is working correctly.
d) make sure that the sensor is correctly aligned in the traction line.
E
A
D
C
B
WLL A B C D E kg
15 t 98 41 146 41 60 7.8
25 t 110 44 178 50 73 14
50 t 150 64 267 70 105 39.7
100 t 241 89 381 95 146 97
250 t 320 125 540 140 200 340
OK
«DANGER»
GB