Chapter 2: Getting started
Getting started with the wired IP Handset
13
2222
Gett
ing s
tar
te
d
Starting up the wired IP Handset
To switch on the IP Handset
The wired IP Handset is automatically powered when it is connected to a LAN
interface with PoE.
If the handset has been switched off, you can switch it back on by pressing
and holding the on hook key until the display lights up.
If the handset does not start up, the reason may be that there is no PoE in the
LAN interface. If you are connecting to a BGAN terminal, check that the PoE
indicator on the terminal lights green for the connected port. For further
information, refer to the installation manual for the BGAN terminal.
To switch off
the IP Handset, press and hold the on hook key again until the
display is turned off.
On/off key
Volume up
Volume down
Содержание FleetBroadband
