TrackingTheWorld WorldTracker AVL, Руководство пользователя

Страница: 80 / 94

Any type off buzzer can be used, but current to the buzzer must be less then 30 mA
or it will damage your tracking unit!
The I-button can be enabled using the configuration menu or use new command code ‘59’.
The AVL will read the I-button when the PARK fencing input LED is flashing. We suggest connecting
the PARK fencing input to the car ignition. So every time the driver removes the keys from the ignition the
PARK LED will start flashing after the PARK fencing delay time.
Once the PARK fencing LED starts flashing the AVL will check for I-button. You will hear 2 short beeps
from the buzzer after reading the I-button.
Once the I-button has been read it stays in memory until you disable and enable PARK fencing again and
the PARK fencing LED starts flashing.
If you forget to use the I-button when you start the vehicle and PARK fencing LED was flashing the buzzer
will generate for 30 seconds a single on/off beep tone. During this time the AVL will read the I-button.
Once the beeping stops it will stop reading the I-button until PARK fencing LED starts flashing again.
The I-button ID is added to the end of the single location message if enabled. Default (or no I-button ID is
read) is : 00000000000000 (14 digital numbers).
The I-button ID is only added to the message if enabled.
Example messages:
05*827,000,L001,A,3500.6644,S,17231.4500,E,000.0,068.4,01.0,01:50:34 18-05-
06,9.00,D8,0,FF,0,00000152231214
ID button: 00000152231214
05*827,000,L001,A,3440.2344,S,17343.2200,E,000.0,068.4,01.2,01:49:37 18-05-
06,9.00,D9,0,FF,0,00000000000000
ID button: 00000000000000
Please note:
- 79 -