B
ENGINE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
77
Repair and Service Manual
699322
can be removed from the drive clutch. Remove the
starter/generator pivot bolts (13) and lift starter/generator
from the vehicle.
Install the starter/generator pivot bolts (13) and hardware
loosely in place and install the belt. Tighten a new
starter/
generator belt per ‘Starter/Generator Belt Tension’ earlier
in this section.
Tighten jam nut (12) and the pivot bolts (13) and nuts (14)
to the specified torque shown in the torque table earlier in
this section.
Install the wiring and tighten the terminals firmly into
place. Reconnect the battery.
Fig. 13 Starter/Generator Wire Connections
Fig. 14 Starter/Generator Wiring Table
COOLING SYSTEM CLEANING
At least once a year, or more often under adverse condi-
tions, the cooling system should be cleaned. Cleaning will
assure an adequate supply of air to the cooling fins. Com-
pressed air may be used for routine cooling system main-
tenance.
Operation in wet or damp weather or overly fresh cut
grass may result in a variety of debris accumulating and
adhering to the internal shroud and fins of the cooling
system.
SPARK PLUG
Tool List
Qty.
Spark Plug Socket,13/16" ............................................1
Feeler Gauge, wire type ..............................................1
Ratchet & Extension ....................................................1
Torque Wrench, ft. lbs..................................................1
This engine uses Spark Plug NGK BPR2ES with a gap of
.028" - .031" (.70 - .80 mm). Using a 13/16" spark plug
socket or wrench, remove the spark plug at 125 hours or
semi-annually and clean and re-gap. The spark plug
should be properly gapped (Ref. Fig. 15) and replaced in
the cylinder head, tighten to the specified torque.
Fig. 15 Gapping the Spark Plug
Fouled spark plugs are indicated by a wet, black appear-
ance. This could be caused by a dirty air filter element or
other restrictions in the air intake system. Incorrectly
adjusted valves, spark plug wires which are in poor condi-
tion or poor quality fuel could also contribute to the prob-
lem.
Use care not to over-tighten the
plug. Over-tightening can cause
damage to the aluminum cylinder
head threads.
FROM
TO
A1
Ground
A2
Terminal F1 on Starter/Generator
F1
Terminal A2 on Starter/Generator
F2
Terminal A on Solenoid
DF
Green wire to Voltage Regulator
F2
A2
A1
DF
ITEM
TORQUE SPECIFICATION
Spark Plug
16 ft. lbs (22 Nm)
0.7 - 0.8 mm
(.028” - .031”)
Gap
Spark Plug
Содержание LS2 2020
Страница 1: ...REPAIR AND SERVICE MANUAL 699322 A Issued May 2019 653635 B...
Страница 16: ...B xiv Repair and Service Manual TABLE OF CONTENTS 655827...
Страница 17: ...B TABLE OF CONTENTS xv Repair and Service Manual 655827...
Страница 18: ...B xvi Repair and Service Manual TABLE OF CONTENTS 655827...