Tracker LS2 2020, Руководство по ремонту и обслуживанию

Страница: 89 / 164

B
REAR AXLE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
71
Repair and Service Manual
699322
Axle Shaft Seal Removal and Replacement
Tools List Qty.
Internal Snap Ring Pliers .............................................1
Seal Puller ...................................................................1
Plastic Faced Hammer ................................................1
Ratchet ........................................................................1
Torque Wrench, ft. lbs..................................................1
Socket, 14mm..............................................................1
1.
Use snap ring pliers to remove the bearing retaining
ring (1) from the end of axle tube (2). (Ref. Fig. 6).
2. Carefully pull axle shaft (3) and bearing out of the
tube.
3. Using a 14 mm socket, remove the hardware (4)
attaching the axle tube to the casing and carefully lift
the tube from the casing studs.
4. Using seal puller, remove axle shaft seal (5)
from casing.
Use care to prevent damage to the
inner surface of axle tube at the
sealing area.
5. Replace the seal by lightly tapping around the cir-
cumference with a plastic faced hammer. Tighten
bolts (4) to 26 - 31 ft. lbs. (35 - 42 Nm) torque.
Axle Shaft Replacement
1. Carefully insert the axle shaft and bearing through
the oil seal.
2. Rotate the shaft until the spline engages with the dif-
ferential side gears.
3. Install the outer snap ring.
4. Coat the outboard spline of the axle with an anti-
seize compound.
5. Install the brake hub and drum, thrust washer and
nut (Ref. Fig. 7).
6. Tighten the castellated axle nut to 70 ft. lbs. (95 Nm)
torque minimum. Continue to tighten until the slot in
the nut aligns with the cotter pin hole.
7. Secure with a new cotter pin
.
Fig. 6 Removing/Installing Seal
Fig. 7 Cut Away of Outer Bearing and Brake Drum
Seal
Puller
A
It is not necessary to
remove brake assembly
for shaft/seal removal
A
2
2
5
1
3
4
Thrust
Washer
Bearing
Outer
Snap Ring Brake
Drum
Axle
Nut
Cotter
Pin
Lock
Washer Spline