Tracker LS2 2020, Руководство по ремонту и обслуживанию

Страница: 87 / 164

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
69
Repair and Service Manual
699322
REAR AXLE
The rear axle is provided with a lubricant level check plug
located on the driver side at the rear of the housing (Ref.
Fig. 2). Unless leakage of rear axle lubricant is evident,
an annual lubricant check is sufficient
For further axle information, see Four Cycle Transaxle
Shop Rebuild and Service Parts Manual.
Refer to REAR SUSPENSION section for axle removal.
NEUTRAL LOCK
To prevent the driven clutch from turning the rear wheels
during service operations and to prevent wear to the belt
while being towed, a neutral lock is located on the direc-
tion selector.
The neutral lock is located on the direction selector. To
operate neutral lock located on the direction selector, first
turn the key switch to ‘OFF’, place direction selector in ‘R’
and remove seat. Pull out (1) and rotate(2) the neutral
lock pin handle so that the pointed portion of the handle
is over the side of the direction selector cam (Ref. Fig. 2).
Move direction selector lever towards the area between
‘F’ and ‘R’. During that motion, the pin will snap into the
hole in the direction selector mounting bracket, prevent-
ing any movement of the lever. When in this position, the
direction selector remains locked in the neutral position.
To activate the direction selector, pull the neutral lock pin
handle out and rotate until the pointed portion of the han-
dle fits into the hole (3) in the direction selector cam.
Spring loaded mechanism. To pre-
vent possibility of fingers becom-
ing pinched in the direction
selector mechanism, hold direction selector lever
when releasing neutral lock pin handle.
Fig. 1 Neutral Lock (Direction Selector)
Checking the Lubricant Level
Tool List Qty.
Socket, 13 mm.............................................................1
Ratchet ........................................................................1
Funnel..........................................................................1
Clean the area around the check and fill plugs. Remove
the check plug. The correct lubricant level is just below
the bottom of the threaded hole. If lubricant is to be
added, remove the fill plug and add lubricant using a fun-
nel. Add lubricant slowly until lubricant starts to seep
from the check plug hole. Install the check plug and the
fill plug. In the event that the lubricant is to be replaced, a
drain plug is provided at the bottom of the differential
housing. Capacity of axle is 51 ounces (1.5 liters).
Fig. 2 Add, Check and Drain Rear Axle Lubricant
2
1
3
Drain Plug
Fill / Check Plug