Opening your safe for the first time
5
WARNING:
Always perform code change with the door OPEN and the bolts
extended in the locked position.
1) With the door in the open position, enter “zero”(0) six(6) times.
2) Within four (4) seconds, enter the existing six (6) digit code ONE (1)
time.
3) Within four (4) seconds, enter the NEW six (6) digit code TWO(2)
times.
4) Test your new code several times before closing and locking the door.
Valid Code Entry: Two (2) Beeps at the same time as two (2) LED
flashes after valid six(6) digit code is entered.
Invalid Code Entry: Three (3) Beeps at the same time as three (3) LED
flashes and the old code is still valid.
If a mistake is made while programming the new code, wait thirty (30)
seconds and repeat steps 1-3.
SecuRam™ Electronic Lock:
Programing your SecuRam™ Electronic Lock:
1) Turn the handle counter-clockwise until it stops.
2) Enter the factory code 1-2-3-4-5-6.
Each key press is confirmed with a
beep and LED flash to signal an input.
3) The lock will confirm a vaild combination with two (2) beeps at the
same time as two (2) LED flashes.
4) Within four (4) seconds, turn the handle clockwise until the handle
stops.
5) Pull the door open.
Invalid Combination Entry will be confirmed by three (3) beeps at the
same time as three (3) LED flashes.
