Tracer 1150644, Инструкция по эксплуатации, Страница: 7 / 40

Instructions for use
7
TV
Wall Mount
EN
Note:
Before installing or assembling the product, read the entire instructions for use.
WARNING
• Do not begin the installation of the product until you have read and understood the
instructions and warnings contained herein. If you have any question regarding any
of the instructions or warnings, please contact your local dealer.
• This product should only be installed by persons of good mechanical aptitude, with
experience and basic mounting skills, who fully understand the installation instruc -
tions.
• Make sure that the supporting wall will hold the combined load of the mount and all
the attached hardware and components.
• Never exceed the maximum allowed load.
• When mounting to wood wall studs, make sure the mounting screws are anchored
into the centre of the studs. Use of a stud finder is recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can damage the
product, greatly reducing its load.
• This product is intended for indoor use only. Using this product outdoors could lead
to product failure and personal injury.
WARNING
• When installing on cinder blocks, make sure you have at least 3.5cm of actual con -
crete thickness where the holes for the anchors will be made. Do not drill into joints!
Be sure to mount in a solid part of the block - usually at least 2.5cm from the side of
the block. In order to avoid breaking out the back of the hole when entering a void
or a cavity, use an electric drill on slow setting instead of a hammer drill.
• The installer is responsible for ensuring that the supporting wall will hold the com -
bined load of the mount and the attached display and components.