INSTALLATION AND OPERATING INSTRUCTIONS ANCHOR WINCHES
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain this
anchor winch. Protect yourself and others by observing all safety information. Failure to comply with instructions could
result in personal injury and/or property damage! Retain instructions for future reference.
Unpacking
- When unpacking, inspect carefully for any damage that may have occurred during transit. Make sure the winch
is correctly installed before putting unit into service.
SAFETY ISSUES
Read this user manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Only
persons well acquainted with these rules of safe operation should be allowed to use the winch.
Rope breakage
1.
Never allow anyone to be positioned between the anchor and the winch. If the rope breaks it could snap back with
enough force to cause injury.
2.
The winch is shipped with a closed loop anchor roller. If the included anchor roller is ever replaced it must be
replaced by a closed loop anchor roller. The closed loop anchor roller will prevent the anchor line from snapping
onto the boat deck in the event the rope breaks.
3.
Always use an anchor rope with a minimum of 500 pound (226.8 kg) tensile strength for this product. Never
substitute cable for rope. Cable is not an acceptable anchor line as it does not stretch and is easily frayed. If cable
breaks it can snap back with more force than a rope.
4.
This product is intended to lift anchors. Do not attempt to lift or move people or other objects.
5.
Inspect entire rope for weak or worn condition or kinking (short tight twist or curl) before each use. Replace worn
rope with anchor rope with a minimum 500 lb. (226.8 kg) break strength.
Electrical shock and fire hazards
1.
Do not use electrical wire sizes smaller than 14 AWG (gauge) with a 105-C temperature rating. Using wire that is too
small could result in overloading and a fire. Large gauge wire is permitted.
2.
Use the supplied circuit breaker or a 20 amp in-line fuse when installing this winch.
3.
Use only suitable wire for electrical connections between the winch and battery.
4.
Make sure any crimped electrical connectors meet industry strength requirements.
5.
Always disconnect the battery lead wires from the battery before attempting to install, relocate, or service the
winch.
GENERAL SAFETY INFORMATION -
Throughout this manual potential safety hazards will be noted with the following
terms. Please read and understand these terms before operating the product.
Danger means a hazard that
WILL
cause death or serious injury if the
warning is ignored.
Warning means a hazard that
COULD
cause death or serious injury if the
warning is ignored.
Caution means a hazard that
MAY
cause
minor or moderate injury if the warning
is ignored. It may also mean hazard that
will only cause damage to property.
