8
t 5IFTUBUJTUJDTXJMMCFEJTQMBZFEPOUIF-$%JOEFGBVMU:PVDBODIPPTFUPIJEFPSTIPXUIFNJU
through below mentioned method;
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Options”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate “Display Stat.”, and press “Left Key” once to enter
d. Press “Up Key” or “Down Key” to activate your intended item, and press “Left Key” once to
select the item and go back. Press “ZERO Key” to go back to measuring mode.
t #SPXTFUIFTUBUJTUJDTUISPVHINFOV
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Browse Stat.”, and press “Left Key” once to enter
c. Press “Right Key” once to go back. Press “ZERO Key” to go back to measuring mode.
5.1.7. Probe Modes
5IFSFBSFUISFFEJòFSFOUQSPCFNPEFT"650."(BOE&%%:*O"650NPEFUIFQSPCFDBO
automatically determine the type of substrate measured. In MAG mode, the probe can only mea-
TVSFPONBHOFUJDTVCTUSBUFT*O&%%:NPEFUIFQSPCFDBOPOMZNFBTVSFPOOPOGFSSPVTNFUBM
substrates. When a magnetic substrate is detected, an “F” will be shown on the right side of the
readings, and when a non-ferrous metal is detected, an “N” will be shown. User can switch probe
modes as below;
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Options” item, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate “Probe Mode” item, and press “Left Key” once to enter
5.1.8. Storage
In general group mode (GENn), readings and statistics will be stored and not lost when you turn
off the instrument. In direct group mode (DIR), readings and statistics will be lost when turning
off the instrument.
Each group has an individual high/low limit alarm, zero calibration and multi-point calibration,
user can change these settings, which will be stored.
In addition, you can also set the system settings (Measuring Mode, Group Mode, Probe Mode
etc.), these settings will also be stored.
Note: When the battery capacity is low, user must replace the batteries in time. Before replacing
the batteries, please turn off the instrument.
5.1.9. Recall and Delete Readings
t %FMFUFUIFMBTUSFBEJOHT 5JQJONFBTVSJOHNPEFQSFTTUIFi;&30,FZwPODF
a. Press “Left Key” once to enter into menu mode (”Root” directory)
b. Press “Up Key” or “Down Key” to activate “Delete Data”, and press “Left Key” once to enter
c. Press “Up Key” or “Down Key” to activate” Current Data”, and press “Left Key” once. A dialog
box will be displayed.
d. Press “Left Key” once to confirm the selection and go back, or “Right Key” to cancel and go
back. Press “ZERO Key” to go back to measuring mode.
EN
