Issue Date: 08/09/19 Rev. Date:
Rev. Level: - ECO 1-7553
OIPM P/N: 8213 Page 6 of 9
HEATER INSTALLATION continued
Y
our OCH2 series heater can be mounted with either
adjustable mounting brackets or chain suspension.
Both options are included with your heater.
Standard Mounting:
In the carton insert shipped with your heater you will
find two adjustable mounting brackets and a hardware
pack with fastening hardware. Using the mounting
centers specified in figures 1 & 2, mount your adjust
-
able mounting brackets (bends to the inside). Once
mounted, assemble the heater to brackets (figure 3)
with mounting hardware, these brackets enable the
heater to be angled in 15-degree increments up to 45
degrees.
Chain Suspension:
The heater can also be chain-hung as shown in figure
4. Cut the 16ga. chains (two 4 foot chains are provid
-
ed) to desired length. Attach chains to heater with “S”-
hooks provided and suspend from overhead structure.
Crimp “S”-hooks closed after assembly.
Figure 1: end view
Figure 2: side view
ELECTRICAL SHOCK
HAZARD
•
Serious injury or death
may occur.
•
Disconnect from electrical
supply before installing or
servicing any heater.
• Read and follow
installation clearance
requirements on page 4.
Figure 3: mounting view
10-32 x ½”
Screws
Mounting
Bracket
10-32 Nylon
Lock Nut
Install heater so that the quartz tubes are horizontal.
Failure to do this may cause the heating element
within the tube to sag and cause premature burn
-
out.
647
64
5 9
16
334
0° TO 45° AT
15° INCREMENTS
OCH2-66 = 65.0"
OCH2-66 = 66.0"
OCH2-55 = 55.0"
OCH2-55 = 54.0"
