Note:
(1) Please be careful when threading the handpiece to the connector; do not use
excessive force.
(2) When using the handpiece, please install the drill or chuck to simulate actual
cutting pressure.
4.7
Three Way Syringes: Hold down the ring collar to insert an air/water syringe;
release the collar ring when inserted to hold the syringe tip. To release the tip,
depress the ring collar; remove the tip, then release the collar ring. The
air/water syringe must be fully inserted up to the indication line.
4.8
Clean water bottle: The clean water bottle will supply the water for the high &
low speed handpieces and the three way syringe. Distilled water should be used
to prevent handpieces and three way syringes clogging from hard water mineral
deposit buildup. When adding water, please turn off the net bottle switch,
rotate the bottle clockwise to remove the bottle, after filling bottle, to tighten
turn bottle counter-‐clock wise.
Notice: Before adding water, please turn off the net water switch.
4.9
Air System: Prior to packaging, the oil-‐free compressor has passed all quality
tests. Open the pressure switch will start the air compression. The air
compressor pressure gauge should slowly rise from 0 bar to 8 bar. When the
pressure in thank drops below 5 bar, the air compressor should start
automatically until the pressure build up to 8 bar.
Notice:
Do not operate or disassemble this equipment without professional
guide in order to avoid injury or unit damage.
5.
Operation and Maintenance
5.1
Operation: The machine should operate in normal room temperature from 5-‐
40’C and relative humidity not greater than 80%. Surrounding area of the
machine should be clean, dry free of corrosive gas, well ventilated with indirect
sunlight.
Notice:
The machine should be placed firmly, evenly leveled on a hard flat
surface.
After Opening: Check to see if the machine is in good condition and has all its
components outlined in the packing list.
