TP-Link TL-WA901ND, Руководство по установке

Страница: 13 / 86

12
English
T1. How do I restore my AP’s configuration to its factory default settings?
With the Access Point powered on, use a pin to press and hold the WPS/RESET
button on the rear panel for 5 to 8 seconds before releasing it.
T2. What can I do if I forget my password?
1. Try to use the default user name and password: admin, admin;
2. Referring to the file that you have saved in Finish last time you configured the
device. The file will show you the user name and password that you have
configured.
3. If the password is still not the correct one, then you can try to restore the Access
Point’s configuration to its factory default settings referring to previous section T1
and try to reconfigure your AP by following the instructions of this QIG.
T3. What can I do if I cannot access the web-based configuration page?
1. Make sure your wired device’s IP address is set as “Obtain an IP address
automatically”.
2. Check to see if you have input the correct address http://tplinkap.net in the
address bar of your browser.
3. Please make sure your hardware connection is OK. You can confirm this by the
LAN LED on the front panel of TL-WA901ND. If the LED of the LAN port, which
your Ethernet cable is connected to, is lighting green, your hardware connection
is OK; otherwise, please check your hardware connection carefully.
4. If the problem still persists, please feel free to contact our technical support.
Appendix 2: Troubleshooting
Note
Once the Access Point is reset, the current configuration settings will be lost
and you will need to reconfigure the Access Point.