15
Smart Switch
Connection
ChaCter 2
Ethernet Port
21C
Please connect the Ethernet ports of the switch to the network devices by RJ45 cable
as the following figure shown.
RJ45 Port
RJ45 Cable
Connecting the RJ45 Port
Figure 4-1
SFP Port
211
Connect the SFP port to a SFP module. For the switch, if an SFP transceiver (purchased
separately1 is installed in a slot and has a valid link on the port, the associated RJ45
port will be disabled and cannot be used.
SFP Port
Connecting the LAN Port
Figure 4-2
Note:
SFP module supports hot-plugging, plug the SFP module into the SFP port and the
■
switch can identify it automatically.
The SFP port
■
supports 100/1000Base-FX SFP module at full-duplex mode. When
using a SFP module, you need to log on to the GUI of the switch and configure the
corresponding Speed and Duplex mode on Switching
→
Port
→
Port Config page.
For 100M module, please select 100MFD while select 1000MFD for gigabit module. By
default, the Speed and Duplex mode of SFP mode is 1000MFD.
Connection
SFP Module