IEEE802.3x flow control for Full Duplex mode and backpressure for Half
Duplex mode. It is compatible with all 10,100, and 1000Mbps Ethernet
devices because it is standard-based.
The TP-LINK TL-SL1109/TL-SL1117/TL-SL1226 is plug-and-play and no
configuration is required. Auto MDI/MDI-X cable detection on all ports
eliminate the need for crossover cable or Uplink port. Each port can be used
as general ports or Uplink ports, and any port can be simply plugged into a
server, a hub, a router or a switch, using the straight cable or crossover cable.
Diagnostic LEDs which display link status and activity, allowing you to quickly
detect and correct problems on the network.
1.2 Features
Ø
Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab standards
Ø
8/16/24 10/100Mbps Auto-Sense RJ45 ports supporting Auto-
MDI/MDIX
Ø
1/1/2 10/100/1000Mbps Auto-Sense RJ45 ports supporting Auto-
MDI/MDIX
Ø
Supports IEEE802.3x flow control for full-duplex model and
backpressure for half-duplex transfer model
Ø
Non-blocking switching architecture that forwards and filters packets at
full wire-speed for maximum throughput
Ø
Supports MAC address auto-learning and auto-aging
Ø
LED indicators for monitoring power, link, activity, speed
Ø
19
”
rack-mountable steel case
Ø
Internal power supply
Chapter 2: Installation
2.1 Mounting the Switch on a Desk
Before place the Switch on a desk, attach four rubber footpads to the flutes on
the Switch bottom, then lay the Switch on the desktop, where can be have as
much as 5kg placed on top.
Note
: Make sure there is a grounded AC outlet within 1.5 meters, and
working well.
Make sure there is free space for radiating heat and air.
Make sure not to place anything to heavy on top of the switch.
2.2 Mounting the Switch in a Rack
The dimension of TL-SL1117/TL-SL1226 is designed according to the
standard 19'' rack-mountable steel case of Electronic Industries Association.
TL-SL1109 can't mount in Rack.
Turn off all the equipment connected to the Switch before mounting it in the
rack, then rivet the two
“
L
”
brackets onto each side of the Switch, fasten it with
screws in the rack.
Figure 2-1 Rivet the
“
L
”
brackets onto the Switch
24+2G Gigab
it Switch
Power
1000M
2
4
6
8
10 12 14
16 18 20
22 24
1
3
5
7
9
11 13 15
17 19 21
23
TL-SL1226
Link/Act
Link
Link
Act
Act
100Mbps
100Mbps
GIGA1 GIGA2
GIGA2
GIGA1
10/100/1000
Mbps
9
11
13
15
10
12
14
16
1
3
5
7
2
4
6
8
17
19
21
23
18
20
22
24
10/100Mbp
s
TL-SL1109/TL-SL1117/TL-SL1226
Gigabit Ethernet Switch User's Guide
TL-SL1109/TL-SL1117/TL-SL1226
Gigabit Ethernet Switch User's Guide
3
2
