Page 4 |
03/16
3.
When prompted, authenticate with:
Username: admin
Password: admin
This information can be found on the Default Settings
sticker under the battery cover
If no prompt appears, confirm:
A.
TP-Link has power and is turned on
B.
Wi-Fi is turned on and connected
C.
No static IP is set for TP-Link’s Wi-Fi network
D.
TP-Link has been restored to factory defaults (as
explained in Section 1)
4.
Continue to Section 5 to provision TP-Link
Section 5: Provisioning TP-Link
1.
Navigate to Operation Mode in the left-hand
navigation bar
2.
Change Operation Mode to WISP Client Router
Mode and click Save
After clicking Save, TP-Link will reset (will take
approximately one minute)
If webpage fails to appear after reboot when
using Wi-Fi, make sure that TP-Link is still the
device’s active connection
3.
Navigate to Network in the left-hand navigation bar,
then select LAN from Network’s submenu
4.
Change IP Address to
192.168.100.5
and click Save
After clicking Save, TP-Link will reset (will take
approximately one minute)
After saving, you must go to
192.168.100.5
to
configure device (instead of
192.168.0.1
)
If webpage fails to appear after reboot when
using Wi-Fi, make sure that TP-Link is still the
device’s active connection
If webpage still fails to appear after reboot and device is connected, forget the network
connection on user’s device, then try again
5.
Navigate to DHCP in the left-hand navigation bar, then select DHCP Settings from DHCP’s submenu
6.
Confirm/Set the following (if any changes made, user must perform steps 9 & 10):
A.
DHCP Server is enabled
B.
Start IP Address is set to 192.168.100.100
C.
End IP Address is set to 192.168.100.199
7.
Navigate to Wireless in the left-hand navigation bar, then select Wireless Security from submenu
8.
Select Disable Security to remove any Wi-Fi password
If a password is desirable, select WPA/WPA2 – Personal and enter desired password
If any changes made, user must perform steps 9 & 10
9.
Navigate to System Tools, then select Reboot from System Tools’ submenu
10.
Click Reboot to reboot device and commit any changes made in steps 5-8
If webpage fails to appear after reboot when using Wi-Fi, make sure that TP-Link is still the device’s
active connection
F
IGURE
8:
I
OS
W
I
-F
I
D
ETAILS
F
IGURE
9:
TP-L
INK
C
ONFIGURATION
S
TART
-S
CREEN