TD-W8951NB
150Mbps Wireless N ADSL2+ Modem Router(Annex B) User Guide
¾
Default Route:
If enable this function, the current PVC will be considered as the default
gateway to internet from this device.
¾
TCP MTU Option:
Enter the TCP MTU as your desire.
¾
Dynamic Route:
Select this option to specify the RIP (Routing Information protocol) version
for WAN interface, including
RIP1
,
RIP2-B
and
RIP2-M
. RIP2-B and RIP2-M are both sent in
RIP2 format, the difference is that RIP2-M using Multicast, while RIP2-B using Broadcast
format.
•
Direction:
Select this option to specify the RIP direction.
None
is for disabling the RIP
function.
Both
means the ADSL modem router will periodically send routing information
and accept routing information, and then incorporate them into routing table.
IN only
means the ADSL modem router will only accept but will not send RIP packet.
OUT only
means the ADSL modem router will only send but will not accept RIP packet.
¾
Multicast:
Select IGMP version, or disable the function. IGMP (Internet Group Multicast
Protocol) is a session-layer protocol used to establish membership in a multicast group. The
ADSL ATU-R supports both IGMP version 1 (
IGMP v1
) and
IGMP v2
. Select “Disabled” to
disable it.
2) Static IP Address
Select this option if your ISP provides static IP information to you. You should set static IP address,
IP subnet mask, and gateway address in the screen below (shown in Figure 4-8).
Figure 4-8
24
