Refer to
Step 5
of
Option 1
to relocate your
Range Extender.
Entertainment Adapter
Troubleshooting and Support
The Range Extender RE210 can be used as a wireless
adapter to connect any Ethernet-enabled device,
such as a Blu-ray player, game console, DVR, or smart
TV, to your wireless network.
First, connect the Range Extender to your Wi-Fi
network following the instructions in Option 1 or
Option 2, then connect an Ethernet-enabled device
to the Range Extender using an Ethernet cable as
shown in the diagram on the right.
1
Plug the Range Extender into a wall outlet
close to your router, and wait until the Power
LED is lit and solid green.
A.
Press the
WPS
button on your router/AP.
Note:
For more information about using WPS on your
router, please refer to the router manufacturer's user guide.
B.
Immediately push the
RE
button on your Range
Extender.
2
OP
TI
ON
Using WPS (Wi-Fi Protected Setup)
Power On
3
Relocate
2
Connect
If the RE LED does not switch from blinking to a solid
green, please refer to Option 1.
Important:
In order to use this option, your router must support WPS.
Keep away from
Enjoy!
Enjoy!
To minimize wireless interference, place your Range Extender in an open
space area, away from other bluetooth devices or radioactive devices such
as cordless phone, microwave, etc.
The Range Extender shares the same wireless network name (SSID) and
wireless password as your router.
Ideal Range Extender Placement
YourNetworkName
and password
YourNetworkName
and password
5G
2.4G
The “ ” LED should change from
flashing to solid, showing that WPS
connection was successful.
RE
Power
RE
Power
Smart TV
Game Console
Desktop
Laptop
Smartphone
Tablet
Ethernet Connection
Wireless Connection
My router has no WPS button, how do I connect
the Range Extender?
Your router does not support WPS, please use Option
1 to setup the Range Extender using a web browser.
Why does the WPS LED not change from blinking
to solid green after completing Option 1?
• You may have entered the wireless password of your
router incorrectly during the configuration. Please
login to the Extender’s web management page, and
double-check your router’s wireless password.
1
2
• If the RE LED still keeps blinking, please reset the
Extender and go through the configuration
again.
What should I do when the WPS LED is on, but
only one band is connected?
It depends on your router capabilities, if either the
2.4G or 5G LED is not on while the Extender
connected to your router/network, press the WPS
button on the router and the Range Extender
again to connect the other band.
3
What do I do if I cannot access the Extend-
er’s web management page?
• Make sure your computer is connected to
the Extender’s network.
• Change the computer’s fixed IP address to
Obtain an IP Address Automatically
.
How do I restore the Range Extender to its
factory default settings?
While the Range Extender is plugged into a
power outlet, press the
Reset
button for 5
seconds until all the LEDs flash once.
5
4
