Toyotomi TAG-A70IV, Руководство по обслуживанию

Страница: 15 / 32

– 14 –
TROUBLESHOOTING GUIDE
CHECK A FOLLOWING STEPS
ALARM
INDICATION TIME
APPEARANCE, PORTION, PARTS
SEEMED WRONG
METHOD OF CHECK
(press the ON/OFF button of remote controller in case of reset)
ELECT
(green) TIMER
(yellow)
OPERATE
(green)
INDICATION LAMP
check the drain hose by eyes (it might be folded or choked)
check the RC whether lean or not
not cool down
not warm up
water leakage
louver doesn' t work
※
In this table RC means indoor unit and AE means outdoor unit.
check the resistance by tester [see fig.5]
check the point of leakage measure the pressure of compressor
during fixed operation (emergency and test operation)
nasty smell
FILTER IS CHOKED
NO USE FOR A LONG TIME
NASTY SMELL
(CIGARETTE, FURNITURE, ETC.)
DRAINAGE
MIS-INSTALLATION
LOUVER MOTOR
GAS LEAKAGE
SENSOR, TEMP. ROOM
SENSOR, TEMP. HEAT EXCHANGER
4-WAY VALVE
SHORT CYCLE
(INSUFFICIENT AIR CIRCULATION)
check by eyes and clean it
use deodorizer
check the resistance by tester [see table 1]
- - - -
- - - -
- - - -
- - - -
check the resistance by tester [see table 2]
FAN MOTOR (RC)
check the voltage between blue and yellow in connector [see fig.3]
if it is AC 110V ~ 230V, RC fan motor should be replaced
check the resistance by tester [see fig.4]
check the blockage of air inlet & outlet of RC, AE
2-way valve coil
5.8k Ω
〔
fig. 3
〕
Voltage of TAN fan motor on the PCB(TAN main)
〔 fig. 1 〕 Voltage of AE fan motor on the AE PCB
〔
fig. 4
〕
Resistance of 4-way valve coil
〔 fig. 5 〕 Resistance of 2-way valve coil
※ Take off the connector and check the Resistance of 4-way
valve coil.
〔 fig. 2 〕 Continuity of current fuse on the AE PCB
4-way valve coil
1.5k
Ω
Normal:1.5k
Ω
0 Ω
Measure the voltage between white and black in the connector.
11
AC230V
WBR
B
:BLACK
:BROWN
:WHITE B
BR
W
〔 fig. 6 〕 Resistance of louver motor
common terminal
360 〜 390 Ω
BL
PCB(TAG main)
TAN fan motor connector
R Y B W
Measure the voltage between
the connector pins in the back
of PCB (TAN main) during
cooling operation.
PCB(TAN main)
is Normal
between red
＋
and black
−
approx.DC325V
between yellow ＋ and black − approx.DC3
〜
5V
between white ＋ and black − approx.DC15V
Take off the joint connector of 2-way
valve(TAN), and measure the
resistance of it.
Normal:5.8k Ω
Normal:360 〜 390 Ω
Take off the connector and check the resistance between
the teminals