6
Your heater can be arranged to ignite automatcally at a chosen time by use of a pre-set
“Timer”. This “Timer” can only be set after the clock setting has been completed.
TIMER IGNITION
1
4
3
2
1. Press the
button and then the “Timer” key immediately
after that. The Timer Lamp and Digital Indicator will start
blinking.
2. To set the “Timer” to the chosen igntion time, you should
follow the same procedure as given earlier for “Clock” time
setting. After approximately 10 seconds, the digital indicator will return to “Clock”
mode, displaying the present time.
3. Your heater will now automatically start up the pre-set time.
4. If you wish to start up the heater at the pre-set time again, repeat the same
procedure 1. mentioned above.
NOTE: The pre-set time will remain so long as the heater receives electrical power.
In the event of power failure or disconnection of heater for more than 10
minutes, timer setting will be cancelled.
NOTE: If normal ignition was used to set the heater burning (i.e. the heater is
burning but the Timer Lamp on the Indicator panel is out), pressing the Timer
key will extinguish the heater, and the heater will be put into the
“Timer”mode.
LC-41 10.7.21 2:48 PM ページ 6
