Toyotomi HTN/HTG-09IV, Руководство пользователя

Страница: 13 / 80

13
B GB
Introduction for buttons on remote controller
SLEEP :
Press this button to go into the SLEEP operation mode. Press it again to cancel this
function. This function is available in COOL, HEAT (Only for models with heating
function) mode to maintain the most comfortable temperature for you.
LIGHT:
the display’s light. If the light is turned on , ,
disappears.
Combination of “+” and “-” buttons: About lock
Press “+” and “-” buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
is displayed. In this case, pressing any button, blinks
three times.
Combination of “MODE “ and “-” buttons:About switch between Fahrenheit and Centigrade.
unit OFF, press “+” MODE and “-” buttons simultaneously to switch between
ʝ and ʞ
Replacement of Batteries
1. Remove the battery cover plate from the rear of the remote controller.
gure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
Notes:
cause malfunction.
t If the remote controller will not be used for a long time, please remove batteries to prevent
batteries from leaking.
t
The operation should be performed in its receiving range.
d n u o s o e r e t s r o t e s V T e h t m o r f y a w a m 1 t p e k e b d l u o h s t I
t
sets.
t If the remote controller does not operate normally, please
take the batteries out and reinsert them after 30 seconds.If it
still can’t operate properly, replace the batteries.
13
14
15
16
Sketch map for
replacing batteries