Page 6
TOYOTA
REMOTE ENGINE STARTER
TOYOTA
REMOTE ENGINE STARTER
Page 7
OPERATION
REMOTE ENGINE START (vehicles without Smart Entry System)
STEP 1. Press and release the LOCK button twice within two seconds. The hazard lights
will flash each time.
LOCK
STEP 2. Press and hold the LOCK button for three seconds. The hazard lights flash once
when pressed, then again after three seconds. The engine starts, and the hazard
lights flash for 20 seconds.
OPERATION
REMOTE ENGINE START (vehicles with Smart Entry System)
LOCK
LOCK
NOTE: Any vehicle started with the Remote Engine Starter can idle for a total of 20
minutes.Automatic engine shutdown occurs after 10 minutes, but the vehicle may be remotely
started as many times as the user wishes and run for an additional 10 minutes. After 20 min-
utes of total operation, however, the vehicle must be started manually to reset the Remote
Engine Starter.
NOTE: For vehicles equipped with Piezo, the buzzer will chirp the same number of times that
the light flashes.
For any questions or concerns about the Remote Engine Starter, please call Toyota
Customer Experience at (800) 331-4331.
LOCK
A) Press and
release the
LOCK button.
B) The hazard
lights flash
once.
D) The hazard
lights flash again.
C) Press and
release the
LOCK button
again.
TWO SECONDS
THREE SECONDS
A) Press and
hold the
LOCK button
for three
seconds.
B) The hazard
lights flash
once.
D) The engine
starts and the
hazard lights
flash for 20
seconds.
C) After three
seconds, the
hazard lights
flash again.
FOLLOWED IMMEDIATELY BY:
NOTE: Your vehicle may be equipped with either remote pictured here.
NOTE: For vehicles equipped with Piezo, the buzzer will chirp the same number of times
that the light flashes.
20 SECONDS
To start a non-Smart Entry vehicle remotely, press and release the LOCK button twice within
two seconds, then press and hold the LOCK button for three seconds.
FOLLOWED IMMEDIATELY BY:
TWO SECONDS
A) Press and
release the
LOCK button.
B) The hazard
lights flash
once.
D) The hazard
lights flash again.
C) Press and
release the
LOCK button
again.
D) The engine
starts and the
hazard lights
flash for 20
seconds.
20 SECONDS
STEP 1. Press and release the LOCK button twice within two seconds. The hazard lights
will flash each time.
STEP 2. Press and hold the LOCK button for three seconds. The hazard lights flash once
when pressed, then again after three seconds. The engine then starts, and the
hazard lights flash for 20 seconds.
To start a Smart Entry vehicle remotely, press and release the LOCK button twice within two
seconds, then press and hold the LOCK button for three seconds.
THREE SECONDS
A) Press and
hold the
LOCK button
for three
seconds.
B) The hazard
lights flash
once.
C) After three
seconds, the
hazard lights
flash again.
