Page 4
TOYOTA TVIP SYSTEM PROGRAMMING−RS3200
REPROGRAM EXISTING REMOTE CONTROLS
Follow this procedure to clear all existing remote control codes and reprogram existing remote controls to
a system. When existing remote controls are reprogrammed, they will work in the default operation mode
(press the UNLOCK button twice to unlock all doors and no AUX button function on 4 button remote
controls); to change the operation mode, you must perform the separate REMOTE CONTROL
FUNCTION SELECT procedure as shown on pages 6 and 7.
*If the system does not activate the lights, buzzer and door locks 2 times, start over.
1. Before you begin:
Open the driver s door and remove the key
from the ignition switch.
2. Start
the
programming
procedure.
(Complete these steps within 40 seconds.)
a. Insert the key
into,
and remove it
from
the ignition switch
2
times.
b. Close,
then
open
the driver s door
2
times.
c. Insert the key
into,
and remove it
from
the ignition switch
1
time.
d. Close,
then
open
the driver s door
2
times.
e. Insert the key
into,
the ignition switch
and
leave it in.
f. Close
the driver s
door.
g. Turn the key
from
LOCK to ON 2
times
(ending at
LOCK).
h. Remove the key
from the ignition
switch.
i.
The tail and marker lights flash
2 times,
the
buzzer chirps
2 times and the
doors
lock and unlock 2 times.*
