How to Identify T2wG and Device
How to access the Service Menu
How to access the Repair Manual
How to install latest softwares
TOUCH 2 – Volume Adjustment
Symptoms:
1-
After a phonecall in ECOrunmode, the radio volume has changed
2-
The voice guidance is set to a high volume during a handsfree phonecall
1-
After a phonecall in ECOrun mode, the radio volume has changed
Phenomenon description:
In ECOrun mode, with the mobile phone connected via Bluetooth. If the volume is changed
during a phonecall, the changed volume of the phonecall will be retained as the radio volume.
Supplier: Fujitsu Ten / Denso Ten
This phenomenon can occur on the following vehicles (see table) on DA software lower than
mentioned in below table.
The problem has been resolved as from the software version shown below table or higher.
Vehicle Model
Minimum Required Software Version
Hilux
FE3063
Verso S
FE3063
Yaris
XE3934
Alphard
XE3934
Hilux MY2015
XE3934
Camry, depends which DA-unit type fitted
GE3934 / VE3934
C-HR
VE3934
How to fix:
Install latest released DA Software. (See hyperlink on the bottom of the page)