PRADO
FI Doc No: PZQ85-33270FI - Issue: 2 -17/09/18
Page 20 of 23
JUNE 2018 PRODUCTION ONWARDS
Part No: PZQ85-33270
Step 42
•
Connect module side and power side
interconnection connector.
Step 43
Dash Camera Initial Setting
1)
Insert the Micro SD card into the Dash Camera.
2)
Re connect the battery
3)
Take the vehicle outside and park in open area to get
proper GPS signal.
4)
Turn off the power (ACC OFF) and wait until the Dash
Camera LED light is off (for about 1 minute)
5)
Perform the calibration setting. Press and hold “Action”
button and turn the vehicle engine ON.
6)
The Dash Camera will start the booting process.
When booting process completed there will be a double
high tone “beep” sound and green LED light will switch ON.
Then release the “Action” button.
If there is no “beep” sound, repeat step 4) – 6) again.
7)
Switch OFF the vehicle engine, and wait until the Dash
Camera LED light is OFF (for about 1 minute).
8)
Start the vehicle engine again
Check the error light. If the error light is still ON, repeat step 7)
again. Error light will switch OFF when GPS signal acquired.
Refit all removed parts and secure all fasteners to the
Service Manual torque specifications.
Reprogram all radio stations and clock settings by
referring to the vehicle's owner manual.
Please place the
owner manual
in the glov
e
box
after installation
is
completed.
Re-connect battery terminal.
Battery Post terminal to be torqued to 5.5Nm +/- 2Nm
