Diagram #: 5
5. Fit the metal clip to the bottom of the headlamp at the previously noted
position. Ensure that the metal clip are located on the abrasive resistant tape
strip and not on the bumper.
See Dia #5.
APPLY
UPWARDS
PRESSURE
IMPORTANT:
Note that screw is as close to
bottom
of vertical headlamp cover slot as
possible.
H4012
ISSUE 2: 10/05/10
Part No. PZQ14-60120
Page 4 of 4
FJ CRUISER
ACRYLIC HEADLAMP COVERS
Accessory Part No.
PZQ14-60120
Diagram #: 6
6.To complete installation, insert the top clip between the headlamp
assembly. Position the bottom slot over the metal clip aligning the hole in the
clip with the slot in Headlamp Cover, press down over the metal clips and at
the same time apply upwards pressure to Headlamp Cover. Then secure the
Headlamp Cover with screws and washers provided.
See Dia #6
.
1
2
3
Once the Headlamp Cover is correctly positioned, Clean the headlight lens with the
alcohol wipe provided, as shown. Remove any residue with a clean dry cloth. Peel
the protective strips from dual-lock discs then apply pressure to the dual-lock discs to
ensure it adheres to the headlamp.
TO REMOVE
: Disengage the dual-lock discs, undo the screws from metal clips and
carefully ease the Headlamp Cover from headlamp assembly.
