Toyota PT398-00100, Руководство по установке

Страница: 14 / 44

TOYOTA TUNDRA 2010 - TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 14 of 44 pages
Issue: E 04/07/10
Confirm the following:
3. Hood Latch Replacement. (steps a-o)
(a) Loosen the Plastic Cover from the Hood
Latch Unit. (Fig. 3-1)
CAUTION: Protect the Radiator.
(1) Remove 1 Screw from the Top.
(2) Remove the Nut Cover.
(3) Discard the Nut Cover.
(b) Angle the Plastic Cover downward.
(Fig. 3-2)
Fig. 3-2
Nut
[2] You must Replace Hood Switch.
Hood Switch Kit is Required.
Use Section 3 Hood Latch
Replacement. (pg. 12)
[1] Does the Vehicle have a Hood Switch Installed?
[2] Does not need
Hood Latch Replaced.
Skip to Section 4 V4 Harness
Installation. (pg. 15)
Hood Switch Pre-wire
2P Connector
If the Hood Switch 2P
Connector is not connected,
install the Hood Switch.
If the Hood Switch
2P Connector is connected,
the Hood Switch is already
installed.
Fig. 3-1
Flat Blade & Phillips Screwdriver
Screw
Nut Cover