TOYOTA RAV4/HV 2013
-
CROSSBAR
KIT
Procedure
Page 3 of 6 pages
Issue: G 12/13/2016
3.
Install the Front Crossbar.
(a)
The front crossbar has a “FRONT” sticker
on the center of the bar (Fig. 3-1).
(b)
Install the front crossbar at an angle
parallel with the roof surface (Fig. 3-1).
(1)
Slide the 1
st
support over the side rail.
(2)
Rotate the 2
nd
support forward over the
side rail.
NOTE: Make sure thje clamp is open
enough to clear the side rail. DO NOT
FORCE IT ONTO THE SIDE RAIL.
(c)
Straighten the crossbar so that the front of
the support is 100mm (4 in.) rearward of
the “forward limit” warning label (2 places)
(Fig. 3-2).
(d)
Make sure the FORWARD arrows on the
crossbar supports are pointing toward the
front of the vehicle (Fig. 3-2).
4.
Secure the Front Crossbar.
(a)
Turn the lever clockwise to tighten the
clamp to the crossbar (2 places) (Fig. 4-1).
(b)
After the lever is tight, back off until the
lever lines up with the opening in the
support, and close the lever (2 places) (Fig.
4-1).
(c)
Use the supplied key to turn the lock in the
lever to lock the crossbar in position (2
places) (Fig. 4-1).
1
st
2
nd
Front of
Vehicle
Fig. 3-1
Lock Crossbar
Front of
Vehicle
100mm
(4in.)
Fig. 3-2
Tighten
Lever
Fig. 4-1
