Toyota Prius HSD 2004, Руководство пользователя

Страница: 205 / 330

193
Programming a rolling code system
If your device is “Rolling Code”
equipped, it is necessary to follow
steps 1 through 4 under the heading
“Programming the HomeLink
!
” before
proceeding with the steps listed below.
1. Locate the “training” button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer to the owner’s
guide supplied by the garage door
opener manufacturer for the location of
this “training” button.
2. Press the “training” button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle’s pro-
grammed HomeLink
!
button twice. The
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
motor
should now recognize the
HomeLink
!
unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 each remain-
ing HomeLink
!
button to program
another rolling code system.
Programming an entrance gate/Program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
!
but-
tons you want to program.
2. Place your hand − held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away
from the surface of the
HomeLink
!
.
Keep the indicator light on the HomeLink
!
in view while programming.
3. Press and hold the selected
HomeLink
!
button.
4. Continuously press and release (cycle)
the hand − held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light on the
HomeLink
!
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
!
by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink
!
button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink
!
buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink
!
”.
(b) Operating the HomeLink
!
To operate the HomeLink
!
, press the ap-
propriate HomeLink
!
button to activate the
programmed device. The HomeLink
!
indi-
cator light should come on. The
HomeLink
!
continues to send the signal
for up to 20 seconds as long as the but-
ton is pressed.