Toyota MR2 SW 1993 Скачать руководство пользователя страница 6

Страница: 6 / 6

6. REINSTALL UPPER RADIATOR SUPPORT SEAL
(a) Temporarily install the hood lock with the RH side

bolt.

(b) Place the support seal in position.
(c) Install the hood lock with the two bolts.
(d) Install the seven clips.

(I) Fill coolant into the reservoir tank up to the ”FULL”

line.

(m) Check coolant for leaks.

7. REINSTALL SPARE TIRE
8. REINSTALL DASH PANEL FRONT TRIM COVER
9. REINSTALL REAR FUEL TANK PROTECTOR

(e) install the hood weatherstrip.

–

3S–GTE ENGINE

COOLING SYSTEM

EG1–423

Содержание MR2 SW 1993

Страница 1: ... per form the operation at a level area Performing work with the vehicle inclined may cause improper re moval of coolant or improper air removal when pouring coolant After replacing the coolant check the water level in the water filler and reservoir tank once or twice within 500 km 311 miles of driving or within one week COOLANT CIRCUIT 3S GTE ENGINE COOLING SYSTEM EG1 418 ...

Страница 2: ...cm 12 ft lbf for radiator pipes b Remove the radiator cap CAUTION To avoid the danger of being burned do not remove it while the engine and radiator are still hot as fluid and steam can be blown out under pressure ENGINE COOLANT DRAINAGE 1 REMOVE REAR FUEL TANK PROTECTOR 2 DRAIN ENGINE COOLANT a Set the heater control lever to hot 3S GTE ENGINE COOLING SYSTEM EG1 419 ...

Страница 6: ...sition c Install the hood lock with the two bolts d Install the seven clips I Fill coolant into the reservoir tank up to the FULL line m Check coolant for leaks 7 REINSTALL SPARE TIRE 8 REINSTALL DASH PANEL FRONT TRIM COVER 9 REINSTALL REAR FUEL TANK PROTECTOR e install the hood weatherstrip 3S GTE ENGINE COOLING SYSTEM EG1 423 ...