Toyota LAND CRUISER LC200, Руководство пользователя

Страница: 144 / 973

142
3-2. Opening, closing and locking the doors
LC200_OM_OM60R59W_(WE)
■
Changing the door unlock function setting (vehicles with a smart entry &
start system)
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
Cancel the intrusion sensor and tilt sensor of the alarm system (if equipped)
to prevent unintended triggering of the alarm during the setting change.
(

P. 98)
When the indicator on the key surface is turned off, press and hold or
(if equipped) for approximately 5 seconds while pressing on the
key.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
.)
For vehicles with alarm: To prevent unintended triggering of the alarm, unlock
the doors using the wireless remote control and open and close a door once
after the settings have been changed. (If a door is not opened within 30 sec-
onds after is pressed, the doors will be locked again and the alarm will
automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (

P. 94)
1
2
3
3
Multi-information
display
Unlocking function Beep
(Left-hand drive
vehicles)
Holding the driver’s door
handle unlocks only the
driver’s door.
Exterior: Beeps 3 times
Interior: Pings once
(Right-hand drive
vehicles)
Holding a passenger’s door
handle unlocks all the doors.
Holding a door handle
unlocks all the doors. Exterior: Beeps twice
Interior: Pings once