
234
4-5. Using the driving support systems
HILUX_OM_OM0K198E_(AE)
X
Vehicles with multi-information display
The DPF system warning mes-
sage shown in the illustration
appears on the display, and the
idling engine speed will increase.
Regeneration will take around 30 - 40 minutes to complete.
*
2
When the DPF system warning light or the DPF system warning mes-
sage goes out, the idling engine speed will have finished returning to
normal.
The DPF system switch may not operate when the vehicle is higher
than 4000 m (13123 ft.) above sea level.
*
1
: Depending on the situation, it may be necessary to depress the accelera-
tor pedal until the engine speed is increased to 3000 rpm.
If the engine coolant temperature or exhaust gas temperature is low, it may
take a long time to regenerate, or regeneration may be impossible.
*
2
: Time required for regeneration differs in accordance with the outside tem-
perature. Also, if the engine speed is still approximately 2000 rpm 10 min-
utes after pressing the DPF system switch, the exhaust gas temperature
may be low. In this case, depress the accelerator pedal to run the engine at
approximately 3000 rpm for a while.
●
If the DPF system warning light flashes rapidly (vehicles without
multi-information display) or the DPF system warning message
“DPF FULL VISIT YOUR DEALER”/“DPF full Visit your dealer”
appears on the display (vehicles with multi-information display), the
malfunction indicator lamp comes on, have the vehicle inspected by
your Toyota dealer immediately.
HILUX_OM_OM0K198E_(AE).book Page 234 Thursday, February 12, 2015 6:39 PM
NOT
FOR
REPRODUCTION
Содержание HILUX
Страница 1: ...N O T F O R R E P R O D U C T I O N ...
Страница 2: ...N O T F O R R E P R O D U C T I O N ...
Страница 539: ...N O T F O R R E P R O D U C T I O N ...
Страница 540: ...N O T F O R R E P R O D U C T I O N ...