Toyota Highlander 2020, Руководство пользователя

Страница: 315 / 560

315
4-5. Using the driving support systems
HIGHLANDER_U
4
Dr
iv
ing
■
Turning off both TRAC, VSC
and Trailer Sway Control sys-
tems
To turn the TRAC, VSC and Trailer
Sway Control systems off, press
and hold the switch for more
than 3 seconds while the vehicle is
stopped.
The VSC OFF indicator light will
come on and the “Traction Control
Turned OFF” will be shown on the
multi-information display.
*
Press the switch again to turn
the system back on.
*
: On vehicles with PCS (Pre-Colli-
sion System), PCS will also be
disabled (only Pre-Collision warn-
ing is available). The PCS warning
light will come on and a message
will be displayed on the
multi-information display.
(

P.233)
■
When the message is dis-
played on the multi-information
display showing that TRAC has
been disabled even if the
switch has not been pressed
TRAC is temporary deactivated. If
the information continues to show,
contact your Toyota dealer.
■
Operating conditions of
hill-start assist control
When the following four conditions
are met, the hill-start assist control
will operate:
●
The shift lever is in a position
other than P or N (when starting
off forward/backward on an
upward incline)
●
The vehicle is stopped
●
The accelerator pedal is not
depressed
●
The parking brake is not engaged
■
Automatic system cancelation
of hill-start assist control
The hill-start assist control will turn
off in any of the following situations:
●
The shift lever is shifted to P or N
●
The accelerator pedal is
depressed
●
The parking brake is engaged
●
2 seconds at maximum elapsed
after the brake pedal is released
■
Sounds and vibrations caused
by the ABS, brake assist, VSC,
Trailer Sway Control, TRAC and
hill-start assist control systems
●
A sound may be heard from the
engine compartment when the
brake pedal is depressed repeat-
edly, when the engine is started or
just after the vehicle begins to
move. This sound does not indi-
cate that a malfunction has
occurred in any of these systems.
●
Any of the following conditions
may occur when the above sys-
tems are operating. None of these
indicates that a malfunction has
occurred.
• Vibrations may be felt through the
vehicle body and steering.
• A motor sound may be heard also
after the vehicle comes to a stop.
• The brake pedal may pulsate
slightly after the ABS is activated.
• The brake pedal may move down
slightly after the ABS is activated.
■
Active Cornering Assist opera-
tion sounds and vibrations
When the Active Cornering Assist is
operated, operation sounds and
vibrations may be generated from
the brake system, but this is not a
malfunction.
■
AWD system operation sounds
and vibrations when switching
between AWD and front wheel
drive
When the vehicle switches from
AWD to front wheel drive and vice
versa, operation sounds and vibra-